Introduction: In the realm of signage, durability and stability are paramount. Aluminium post signs offer a sleek and professional appearance, while Postcrete and hole diggers provide a sturdy foundation for securing them in place. In this guide, we'll walk you through the process of installing an aluminium post sign using Postcrete and hole diggers, ensuring a long-lasting and reliable display for your message or advertisement.
Step 1: Gather Your Materials Before you begin, gather all the necessary materials and tools for the installation process. You'll need:
- Aluminium post sign
- Postcrete (fast-setting concrete mix)
- Hole diggers
- Water
- Level
- Measuring tape
- Shovel
- Mixing container and stirring stick
- Protective gloves and eyewear
Step 2: Choose the Installation Location Select a suitable location for your aluminium post sign, ensuring it complies with any local regulations or guidelines regarding signage placement. Consider factors such as visibility, accessibility, and ground stability when choosing the installation spot.
Step 3: Dig the Hole Using the hole diggers, dig a hole that is deep and wide enough to accommodate the post and provide sufficient stability. The depth of the hole should be determined by the height of the post and the recommended depth for the Postcrete mix. Use the measuring tape and level to ensure accuracy while digging.
Step 4: Insert the Post and Pour the Postcrete around the post. Place the aluminium post sign into the hole, ensuring it is centered and upright. Have someone hold the post in position while you pour the mixed Postcrete into the hole, covering the base of the post completely. Use the level to check the post's vertical alignment and adjust if necessary, add the required amount of water and stir the mixture carefully in the hole, ensure to Hold the sign level whilst the Postcrete initially sets (Usually 5-10mins).
Step 5: Allow the Postcrete to Set.
Allow the Postcrete to set and cure according to the manufacturer's instructions. This typically takes a few hours, but it's advisable to wait 24-48 hours before applying any additional stress or weight to the post sign.
Step 6: Finishing Touches Once the Postcrete has fully cured, backfill the hole with soil or gravel to cover the exposed concrete and create a neat finish around the base of the post sign. Double-check the alignment and stability of the sign, making any final adjustments as needed.
Conclusion: By following these simple steps and using Postcrete and hole diggers, you can install an aluminium post sign with ease and confidence. Remember to prioritize safety throughout the installation process and consult any relevant regulations or guidelines before proceeding. With a sturdy foundation in place, your aluminium post sign will stand tall and proud, effectively communicating your message to all who pass by.
NOTE Signs over 2sqm require the posts to be installed and left to set for 24hrs prior to any advertising panel being applied.